1995 Toyota Tercel Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Oxygen Sensor Heater

Oxygen sensor heater may be used only on various models and oxygen sensor applications. See OXYGEN SENSOR APPLICATION  table.

OXYGEN SENSOR APPLICATION

Application/ Model Main Oxygen Sensor Sub-Oxygen Sensor Sensor Heater
Tercel X X (1)(2) X
(1) Heater used on sub-oxygen sensor.
(2) Heater used on main oxygen sensor.
OXYGEN SENSOR HEATER RESISTANCE SPECIFICATIONS (1)

Application Ohms @ 68°F (20°C)
Tercel 11-16
(1) Measure resistance between sensor terminals +B and HT. For terminal ID, see the illustration in the SYSTEM/COMPONENT TESTS article.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.