Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Toyota Tercel Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Manifold Absolute Pressure (Map) Sensor
- Ensure ignition is off. To check MAP sensor supply voltage, disconnect electrical connector from MAP sensor. See the MAP SENSOR LOCATION table.NOTE: MAP sensor may also be identified using appropriate illustration in the THEORY/OPERATION article. The MAP sensor has a vacuum hose connected to it and may be identified by wire colors. See wiring diagram in the WIRING DIAGRAMS article.MAP SENSOR LOCATION
Application Location Tercel Passenger Side Of Engine Bay, On Firewall, Near Wiper Motor - Turn ignition on. Using voltmeter, measure voltage between terminals VC or VCC and E2 of electrical connector on wiring harness. The VC or VCC and E2 terminals are the 2 outer terminals on all models. Voltage should be within specification. See MAP SENSOR SUPPLY VOLTAGE SPECIFICATIONS table.MAP SENSOR SUPPLY VOLTAGE SPECIFICATIONS
Application Volts Tercel 4.50-5.50 - If supply voltage is not within specification, check wiring circuit. See wiring diagram in the WIRING DIAGRAMS article. If supply voltage is correct, turn ignition off. Reinstall electrical connector on MAP sensor.
- To check MAP sensor output voltage, turn ignition on. Disconnect MAP sensor vacuum hose from intake manifold. Connect voltmeter to terminals PIM and E2 of Engine Control Module (ECM). See ECM LOCATION table. See the PIN VOLTAGE CHARTS
article for ECM terminal identification.ECM LOCATION
Application Location Tercel Behind Glove Box - Measure and record output voltage under ambient atmospheric pressure. Attach vacuum pump to MAP sensor.
- Apply vacuum in specified increments and measure MAP sensor output voltage drop at each increment. See MAP SENSOR OUTPUT VOLTAGE DROP SPECIFICATIONS table. Replace MAP sensor if output voltage drop is not within specification.
MAP SENSOR OUTPUT VOLTAGE DROP SPECIFICATIONS
| Applied Vacuum: In. Hg | Output Voltage Drop |
|---|---|
| 3.94 | .3-.5 |
| 7.87 | .7-.9 |
| 11.81 | 1.1-1.3 |
| 15.75 | 1.5-1.7 |
| 19.69 | 1.9-2.1 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
