1995 Toyota Tercel Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Distributor Sensors

DISTRIBUTOR PICK-UP COIL AIR GAP

Application In. (mm)
Tercel (1) *
(1) Distributorless Ignition System (DIS) is used.
DISTRIBUTOR PICK-UP COIL RESISTANCE

Application (1) Pick-Up Coil Terminals Ohms
Tercel (2) (2) *
(1) For proper testing and terminal identification, see the BASIC TESTING article.
(2) Distributorless Ignition System (DIS) is used.
CAMSHAFT POSITION SENSOR RESISTANCE

Application Ohms
Cold (1) 985-1600
Hot (2) 1265-1890
(1) Cold is with temperature of 14-122°F (-10-50°C).
(2) Hot is with temperature of 122-212°F (50-100°C).
CRANKSHAFT POSITION SENSOR RESISTANCE

Application Ohms
Cold (1) 985-1600
Hot (2) 1265-1890
(1) Cold is with temperature of 14-122°F (-10-50°C).
(2) Hot is with temperature of 122-212°F (50-100°C).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.