1995 Toyota T100 BaseFACTORY OEM SERVICE PROCEDURE

Ignition Timing

IGNITION TIMING (Degrees BTDC @ Idle)

Application (1) (2) Base Timing (3) Advance Timing
T100 5 (4)
(1) Check with engine at normal operating temperature, transmission/transaxle in Neutral, parking brake applied, electric cooling fan off (if equipped) and A/C and all accessories off.
(2) With jumper wire installed between terminals TE1 and E1 on data link connector No. 1.
(3) With jumper wire removed from data link connector No.1.
(4) Information not available at time of publication.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.