Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Toyota Pickup BaseFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS
| Component | Component Location |
|---|---|
| ABS ECU (4Runner) (Rear Wheel ABS) | Behind right side of dash. See Figure. |
| ABS ECU (4Runner) (4 Wheel ABS) | Below center of dash. See Figure. |
| A/C Amplifier (Pickup) | Behind right side of dash. See Figure. |
| A/C Amplifier (4Runner) | Behind right side of dash. See Figure. |
| Anti-Lock ECU (Pickup) | Behind right side of dash. See Figure. |
| Cruise Control ECU (Pickup) | Behind dash, left of steering column. See Figure. |
| Cruise Control ECU (4Runner) | Behind dash, left of steering column. See Figure. |
| Engine Control Module (Engine & Electronically Controlled Transmission ECU (A/T) | On right kick panel. See Figure. |
| Engine Control Module (Engine ECU) (M/T) (Pickup) | On right kick panel. See Figure. |
| Engine Control Module (Engine & Electronically Controlled Transmission ECU (A/T) (4Runner) | On right kick panel. See Figure. |
| Engine Control Module (Engine ECU) (M/T) (4Runner) | On right kick panel. See Figure. |
| Headlamp Auto Cut ECU (4Runner) (4 Wheel ABS) | Behind right side of dash. See Figure. |
| Shift Lock ECU (Pickup) | Below front console, forward of gear selector. See Figure. |
| Shift Lock ECU (4Runner) | Below front console, forward of gear selector. See Figure. |
| VPS ECU (Pickup) | Below front console, forward of gear selector. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.