1995 Toyota Paseo AutomaticFACTORY OEM SERVICE PROCEDURE

Cruise Control Systems DTCS

CRUISE CONTROL SYSTEMS DTCS

OEM Code Test Procedures Description
11 Overcurrent/Short In Motor Circuit (2), 4(4)
12 Open In Magnet Clutch Circuit Or Overcurrent/Short In Magnet Clutch Circuit (2),46(4)
13 Position Sensor Circuit Fault Or Open In Actuator Motor Circuit (2),4(4)
21 No Speed Sensor Signal To CC ECU 5(4)
23 (5) Vehicle Speed Decreased 10 MPH Or More Below Speed Set During Cruise Control Operation (3),54(4)
32 Short In Control Switch Circuit 3(4)
34 Control Does Not Turn Off Before Switching 3(4)
41 Faulty CC ECU (4)
Normal Indicator Light Flashes 5 Times, CC System Can Not Be Set Or Does Not Operate (2),368 or 9(3),4(4)
(1) Perform test numbers in order given.
(2) Check wiring harness and connectors.
(3) Check speed control cable function.
(4) Check CC ECU. See CRUISE CONTROL ECU CIRCUIT TEST Replace ECU as necessary and recheck system operation.
(5) If speed set can be maintained when speed control switch is again set to SET/COAST position, there is no malfunction.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.