1995 Toyota Paseo AutomaticFACTORY OEM SERVICE PROCEDURE

Except Calif.

  1. Remove air control valve, located on end of air intake chamber on passenger's side. Air control valve may also be identified using appropriate illustration in the THEORY/OPERATION article or wire color. See wiring diagram in the WIRING DIAGRAMS article.
  2. Using ohmmeter, check resistance and for continuity between air control valve electrical terminals. Replace air control valve if resistance is not 30-33 ohms.
  3. Ensure no continuity exists between each electrical terminal and air control valve body. Test air control valve operation by applying air pressure to designated area and checking air passage, and then applying battery voltage and ground and retesting. See Fig 1. Replace air control valve if defective or continuity exists between electrical terminals and air control valve body.
Fig 1: Testing Air Control Valve (Except Calif.)
G94E45967Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.