Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Toyota Corolla LEFACTORY OEM SERVICE PROCEDURE
Circuit Opening Relay
- Ensure ignition is off. Remove circuit opening relay. See CIRCUIT OPENING RELAY LOCATION table.NOTE: Circuit opening relay may also be identified using illustration in the THEORY/OPERATION - 1.8L article or wire color. See wiring diagram in the WIRING DIAGRAMS article.CIRCUIT OPENING RELAY LOCATION
Application Relay Location Corolla Bottom Center Of Dash, In Front Of Console, Near Driver's Side Of ECM - Using ohmmeter, check continuity between specified terminals. See Fig 1
- Check circuit opening relay operation by applying battery voltage and ground and checking continuity between specified terminals. See Fig 2 Replace circuit opening relay if defective.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.