Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Toyota Tercel BaseFACTORY OEM SERVICE PROCEDURE
Distributor Sensors
DISTRIBUTOR PICK-UP COIL AIR GAP
| Application | In. (mm) |
|---|---|
| Paseo & Tercel | .008-.016 (.20-.40) |
DISTRIBUTOR PICK-UP COIL RESISTANCE
| Pick-Up Coil Terminals (1) | (2) Ohms | |||||
|---|---|---|---|---|---|---|
| Paseo | ||||||
| G+ & G- | 185-275 | |||||
| NE+ & NE- | 370-550 | |||||
| Tercel (NE & NE-) | 370-550 | |||||
|
||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.