Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Toyota Pickup BaseFACTORY OEM SERVICE PROCEDURE
Engine Controls - Specifications - 4-CYL: Capacities
FLUID CAPACITIES
| Application | (1) Quantity | |||||
|---|---|---|---|---|---|---|
| Crankcase (Includes Filter) | 4.5 Qts. (4.3L) | |||||
| Cooling System (Includes Heater) | ||||||
| 4WD A/T | 9.6 Qts. (9.1L) | |||||
| Except 4WD A/T | 8.9 Qts. (8.4L) | |||||
| Manual Transmission (SAE 75W-90/API GL-4) | ||||||
| 2WD | 2.7 Qts. (2.6L) | |||||
| 4WD | ||||||
| Model G58 Trans. | 4.1 Qts. (3.9L) | |||||
| Model W56 Trans. | 3.0 Qts. (2.9L) | |||||
| Automatic Transmission (Dexron-II) | ||||||
| 2WD | ||||||
| Dry Refill | 6.9 Qts. (6.5L) | |||||
| Drain & Refill | 2.5 Qts. (2.4L) | |||||
| 4WD | ||||||
| Dry Refill | 8.0 Qts. (7.6L) | |||||
| Drain & Refill | 2.1 Qts. (2.0L) | |||||
| Differential | ||||||
| 2WD (SAE 80W-90/API GL-5) | 1.9 Qts. (1.8L) | |||||
| 4WD | ||||||
| Front | ||||||
| With Locking Hubs (SAE 80W-90/API GL-5) | 1.7 Qts. (1.6L) | |||||
| Without Locking Hubs (SAE 75W-90/API GL-5) | 2.0 Qts. (1.9L) | |||||
| Rear (SAE 80W-90/API GL-5) | 2.3 Qts. (2.2L) | |||||
| Transfer Case | ||||||
| A/T (SAE 75W-90/API GL-5) | 1.2 Qts. (1.1L) | |||||
| M/T (SAE 75W-90/API GL-5) | 1.7 Qts. (1.6L) | |||||
|
||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.