Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Toyota Tercel BaseFACTORY OEM SERVICE PROCEDURE
No-Load Test
CAUTION:
DO NOT engage starter solenoid for more than 5 seconds during testing or damage to coil winding will result.
- Remove starter. Connect ammeter in series between starter motor terminal No. 30 (battery terminal) and a fully charged 12-volt battery. Connect battery negative to starter case ground. See Fig 1. Connect voltmeter to battery to observe voltage draw readings.
- Connect remote starter or jumper wire to terminal No. 30 and to terminal No. 50 to engage starter. Starter drive pinion gear should extend quickly and spin smoothly. Verify starter amperage draw and battery voltage draw to be within specifications. See NO-LOAD TEST SPECIFICATIONS table. Replace starter if not within specification.
NO-LOAD TEST SPECIFICATIONS
| Application | Max. Amps @ (Volts) | RPM | ||||
|---|---|---|---|---|---|---|
| 0.8 kW (1) | 50 (11.0) | 5000 | ||||
| 1.0 kW (2) | 90 (11.5) | 3000 | ||||
|
||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.