1993 Toyota Corolla Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Clearing Trouble Codes

  1. After performing repairs, clear ECM memory of all stored trouble codes. To clear memory, turn ignition off. Remove proper fuse from fuse/relay box for approximately 30 seconds or more. See FUSE/RELAY BOX LOCATIONΒ  table. See FUSE APPLICATIONΒ  table to remove proper fuse.
  2. Depending on ambient temperature, fuse may need to be removed for more than 30 seconds in colder temperatures. Install fuse. Road test vehicle, and ensure system operates properly. See Figure.
NOTE: Trouble codes may also be cleared by disconnecting negative battery cable. However, other memory functions (clock, radio, alarm, seats, etc.) will be canceled and must be reset.
FUSE/RELAY BOX LOCATION

Application Location
Corolla Driver Side, Front Corner Of Engine Bay
FUSE APPLICATION

Model Fuse (Amperage)
Corolla EFI (15)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.