Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Toyota Previa LE, AWDFACTORY OEM SERVICE PROCEDURE
Idle Speed Control (ISC) System
- Warm engine to normal operating temperature. Ensure idle speed is correct. See ADJUSTMENTS article in the ENGINE PERFORMANCE Section.
- Apply parking brake and place transmission/transaxle in Neutral. Install jumper wire between terminals TE1 and E1 of engine check connector. See Fig 1.
- Engine RPM should increase to 1000-1200 RPM for 5 seconds, then decrease approximately 200 RPM.
- If engine RPM is not as specified, check ISC valve, wiring to ECU, ECU grounds and ECU. If engine RPM was within specification, remove jumper wire. Turn ignition off.
- To check ISC valve resistance, disconnect electrical connector from ISC valve on lower edge of throttle body. Using ohmmeter, measure resistance between terminal B+ and each remaining terminal. See Fig 2.
- Replace ISC valve if resistance is not within specification. See ISC VALVE RESISTANCE SPECIFICATIONS table.
NOTE:
Information not available from manufacturer for checking ISC valve operation for Previa.
ISC VALVE RESISTANCE SPECIFICATIONS
| Application | Ohms |
|---|---|
| Previa | 18.8-22.8 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
