Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Toyota Paseo AutomaticFACTORY OEM SERVICE PROCEDURE
Circuit Opening Relay
- Circuit opening relay controls fuel pump circuit. The Electronic Control Unit (ECU) receives an input signal at STA terminal when engine is cranking. Starter signal is also applied to terminal STA of circuit opening relay.
- Starter signal energizes circuit opening relay during cranking. The circuit opening relay then provides voltage to the fuel pump or fuel pump relay. Fuel pump relay is used on Celica 2.0L Turbo, MR2 2.0L Turbo and.
- On all models except Camry 2.2L, Celica, Corolla, MR2, Paseo, and Tercel, fuel pump switch in airflow meter provides the ground for circuit opening relay. On all other models, circuit opening relay is grounded by the ECU through the FC terminal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.