Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE
EFI Main Relay
- The EFI fuse supplies constant battery voltage to EFI main relay. EFI main relay provides battery voltage to +B terminal of circuit opening relay and engine check connector.
- Depending on model, EFI main relay may either be turned on directly by ignition switch or by M-REL terminal of Electronic Control Unit (ECU).
- Fuel pump should operate with jumper wire between +B and FP terminals of engine check connector and ignition on. If fuel pump does not operate, check EFI main relay and wiring circuit. See I - SYS/COMP TESTS article in the ENGINE PERFORMANCE Section for testing of EFI main relay. See WIRING DIAGRAMS article in the ENGINE PERFORMANCE Section for wiring circuit.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.