1990 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE

Code 14 (Ignition Signal Problem)

ECU will store Code 14 in memory if it does not receive an IGF (ignition detection) signal a specified number of times in succession. See CODE 14 SET SPECIFICATIONSΒ  table.

CODE 14 SET SPECIFICATIONS

Application No. Times w/o IGF Signal
Camry & Celica 4-5
Celica (4A-FE) & Tercel 4
Celica (3S-GTE) 8-11
Cressida, Land Cruiser & Supra 6-8
Pickup/4Runner
4-Cyl. 22R-E 4-5
V6 3VZ-E 6-8
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.