Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE
Throttle Position Sensor (TPS) Specifications
THROTTLE POSITION SENSOR ADJUSTMENT
| Clearance Between Lever & Stop Screw | (1) Ohmmeter Reading At Terminals IDL & E2 | |||
|---|---|---|---|---|
| Cressida | ||||
| .020" (.51 mm) | Continuity | |||
| .035" (.89 mm) | No Continuity | |||
| Land Cruiser | ||||
| .030" (.76 mm) | Less than 2300 Ohms | |||
| .043" (1.09 mm) | Infinity | |||
| Supra Non-Turbo | ||||
| .016" (.41 mm) | Continuity | |||
| .030" (.76 mm) | No Continuity | |||
| Supra Turbo | ||||
| .020" (.51 mm) | Continuity | |||
| .035" (.89 mm) | No Continuity | |||
|
||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
