1990 Toyota Corolla Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS (COROLLA)

Application Fraction Decimal
Camber (Degrees)
Front -11/64 ± 3/4 .172 ± .750
Rear
4A-F Engine
Coupe -43/64 ± 3/4 -.672 ± .750
Except Coupe -37/64 ± 3/4 -.578 ± .750
4A-GE Engine -43/64 ± 3/4 -.672 ± .750
Caster (Degrees)
4A-F Engine
Coupe 1 1/2 ± 3/4 1.500 ± .750
Except Coupe 1 13/64 ± 3/4 1.203 ± .750
4A-GE Engine 1 13/64 ± 3/4 1.203 ± .750
Steering Axis Inclination (Degrees)
4A-F Engine 12 43/64 ± 3/4 12.672 ± .750
4A-GE Engine 12 1/2 ± 3/4 12.500 ± .750
Toe-In (Inches)
Front 1/32 ± 1/2 .031 ± .031
Rear 5/32 ± 1/2 .156 ± .031
Turning Angle (Degrees)
4A-F (Without PS)
Inside Wheel 38 1/2 38.500
Outside Wheel 33 33
4A-F (With PS)
Inside Wheel 37 1/2 37.500
Outside Wheel 32 1/2 32.500
4A-GE (Without PS)
Inside Wheel 37 1/2 37.500
Outside Wheel 32 1/2 32.500
4A-GE (With PS)
Inside Wheel 37 32
Outside Wheel 32 32
Chapter Navigation
Return to Chapter: Wheel Alignment Specifications & Procedures
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.