1990 Toyota Corolla Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Primary Coil Resistance Tests

  1. Disconnect ignition coil so it is isolated from remainder of system. Using ohmmeter, measure resistance between coil positive (+) and negative (-) terminals. See Fig 1 or Fig 2.
  2. If primary resistance is not within specification, replace ignition coil. See IGNITION COIL RESISTANCEΒ  table. If resistance is within specification, proceed to SECONDARY COIL RESISTANCE.
Fig 1: Testing 4WD (4A-FE) Ignition Coil Primary Resistance
G118946Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.