1990 Toyota Corolla Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Engine Controls - Specifications - 4-CYL: Capacities: CAMRY

FLUID CAPACITIES - CAMRY

Application Qts. (L)
Crankcase (Includes Filter) 4.3 (4.1)
Cooling System (Includes Heater)
Man. Trans 6.8 (6.4)
2WD Auto. Trans. 6.7 (6.3)
4WD Auto. Trans. 7.2 (6.8)
Automatic Transaxle (1)
Transaxle
2WD (Dexron-II) 2.6 (2.5)
All Trac (Type "T" (2)) 3.5 (3.3)
Differential
2WD, 3S-FE (Dexron-II) 1.7 (1.6)
All Trac
Front (SAE 75W-90 W/ GL-5 Rating) .74 (.70)
Rear (SAE 90 W/ GL-5 Rating) 1.2 (1.1)
Manual Transaxle
Transaxle
2WD, (Dexron-II) 2.7 (2.6)
All Trac (SAE 75W-90 W/ GL-5 Rating) 5.2 (5.0)
Differential
All Trac (Rear) 1.2 (1.1)
(1) Drain and refill capacity.
(2) Toyota A/T fluid.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.