1988 Toyota Camry Base, StandardFACTORY OEM SERVICE PROCEDURE

Camry 2VZ-FE (Calif. Models)

  1. Inspection is required when trouble code No. 27 exists. Clear trouble codes. See CLEARING TROUBLE CODES under DIAGNOSIS & TESTING  in this article. Warm engine to normal operating temperature.
  2. Drive vehicle between 50 and 62 MPH for at least 5 minutes in 4th or 5th gear (M/T) or "D" range (A/T).
  3. On all models, fully depress accelerator pedal for at least 2 seconds.
    CAUTION: DO NOT  exceed 62 MPH or trouble code will be canceled.
  4. Stop engine and turn ignition off. Repeat previous steps and note if trouble code No. 27 exists again. If trouble code exists again, check sub-oxygen sensor circuit for continuity, shorts or grounds. Replace sub-oxygen sensor if circuit is okay.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.