1988 Toyota 4Runner Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Oxygen Sensor Resistance (With V6 Engine)

Using an ohmmeter, measure resistance between terminals "+B" and "HT" with oxygen sensor at 68°F (20°C). See Fig 1. Resistance should be between 5.1-6.3 ohms at 68° F (20°C). If resistance is not as specified, replace oxygen sensor.

Fig 1: Measuring Oxygen Sensor Resistance
G95401Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.