Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Toyota 4Runner SR5, 22-RTEFACTORY OEM SERVICE PROCEDURE
Miscellaneous Components
MISCELLANEOUS COMPONENTS LOCATION
| Component | Location |
|---|---|
| A/C-Heater Blower Motor Resistor | On Left Side Of Blower Housing. |
| A/C Amplifier | On Evaporator Housing. See Figure. |
| Cold Mixture Heater (W/Carbureter) | Under Intake Manifold. |
| Cruise Control Actuator | On Left Side Of Engine Compartment. |
| Diagnostic Connector | Behind Fuse/Relay Block No. 2. |
| EFI Solenoid Resistor | On Right Side Inner Fender. See Figure. |
| Ignition Igniter | On Side Of Ignition Coil. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.