1987 Toyota 4Runner SR5, 22-RTEFACTORY OEM SERVICE PROCEDURE

Backdoor Unlock Warning Switch: Inspection

Check that there is continuity when the switch is pushed (back door unlock). Check that there is no continuity when the switch is free (back door locked). If continuity is not as specified, replace the switch.

Fig 1: Backdoor Unlock Warning (Switch Continuity)
G50H02012Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.