Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Toyota 4Runner SR5, 22-RTEFACTORY OEM SERVICE PROCEDURE
Wheel Alignment Specifications
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Specification | ||
|---|---|---|---|
| Front | |||
| Camber in Degrees | |||
| Fraction | 43/64 +/- 1/2 | ||
| Decimal | .666 +/- .500 | ||
| Caster in Degrees | |||
| Fraction | 2 5/64 +/- 1/2 | ||
| Decimal | 2.083 +/- .500 | ||
| Toe-In in Inches | |||
| Fraction | 11/64 +/- 3/64 | ||
| Decimal | .166 +/- .042 | ||
| Toe-In in Degrees | |||
| Fraction | 21/64 +/- 5/64 | ||
| Decimal | .333 +/- .083 | ||
| Toe-Out in Turns | |||
| Inner | 21Β° | ||
| Outer | 20Β° | ||
| Steering Axis Inclination (SAI) | 12Β° | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
