Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1986 Toyota Pickup Base, 22-RTE, R151FFACTORY OEM SERVICE PROCEDURE
System Testing: CALIFORNIA
- Check condition of all hoses and tubes. Ensure coolant temperature is below 43°F (6°C). Start engine and ensure a bubbling noise is not heard from Electronic Air Control Valve (EACV).
- Warm engine until coolant temperature is between 64-109°F (18-43°C). Maintain engine speed at 1390 RPM and check that a bubbling noise is heard from EACV.
- Continue to run engine until coolant temperature is above 131°F (55°C). Maintain engine speed at 1390 RPM and check that a bubbling noise is intermittently heard from EACV.
- Allow engine to return to idle and check that a bubbling noise is heard from EACV. With coolant temperature above 64°F (18°C) and engine under heavy load, disconnect vacuum hose from vacuum switch and plug end of hose. Ensure a bubbling noise is not heard from EACV.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
