Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1986 Toyota Pickup Base, 22-RTE, G52FACTORY OEM SERVICE PROCEDURE
Tech Tips: Other Variant
WARNING: This page is about the Pickup DX, 2D Pickup Extra Cab, 2.4 L, G52, which is a different variant/trim than selected.
- A/C Compressor
- Auxiliary Emission Control Systems
- Body Electrical
- Body Interior
- Cooling System (Mechanical)
- Engine Control Systems
- Fuel System
- Fuses & Circuit Breakers
- HVAC Control Systems
- Ignition System
- Lubrication System
- Mechanical
- Solar Ventilation
- Starter
- System
- Vacuum Pumps/Lines/Tanks/Water Trap
- Wiring System (Data Link Connectors, Pwr Dist., Grnd Dist.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.