Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
CARBURETED Models
When the engine is not running, fuel tank vapors flow through vent line into canister for storage. Float bowl vapors flow through the outer vent control valve into canister for storage when the ignition key is in the "OFF" position.
When the engine is running above 1600 RPM and coolant temperature is above 131Β°F (55Β°C), the vacuum switching valve (VSV) opens and canister vapors are drawn into intake manifold for burning. The VSV is an electrically operated solenoid type valve and is opened and closed by a computer. This computer receives input signals from a speed sensor and thermo switch.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
