1982 Toyota Pickup BaseFACTORY OEM SERVICE PROCEDURE

Subaru Models

  1. Turn ignition "ON", but do not start engine. Connect voltmeter negative lead to a good engine ground. Connect positive lead to ignition coil negative terminal.
  2. Voltmeter should read battery voltage (12 volts). If not, proceed to step 4  ). If battery voltage is present, turn ignition switch "OFF", and check air gap at distributor pick-up coil.
  3. If not to specifications, adjust air gap. If OK, disconnect all wires from ignition coil primary terminals, and check both primary and secondary coil resistance. If not to specifications, replace ignition coil. If OK, proceed to step 9). 
  4. Connect voltmeter negative lead to a good engine ground. Connect positive lead to ignition coil positive terminal. Turn ignition switch "ON". Voltmeter should again read battery voltage.
  5. If not, check the power supply harness, ignition switch, fuse, and noise suppressor condenser. Repair or replace components, as necessary.
  6. If battery voltage was present in step 4)  , turn ignition switch "OFF". Disconnect the distributor wire from the ignition coil negative terminal. Turn ignition switch "ON".
  7. Voltmeter should read battery voltage. If so, proceed to step 9)  . If not, turn ignition switch "OFF", and disconnect tachometer wire from ignition coil negative terminal. Turn ignition switch back to "ON" position.
  8. If battery voltage is not present now, replace ignition coil. If voltmeter indicated battery voltage in step 7  ) with tachometer disconnected, check tachometer system for short circuit. Repair or replace, as necessary.
  9. If ignition coil resistance was OK in step 3  ) or if battery voltage at negative coil terminal was present in step 7)  , check for short circuit or open circuit between ignitor and both the ignition coil and distributor pick-up coil.
  10. If wiring from ignitor is OK, replace pick-up coil and ignitor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.