Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Toyota Corolla BaseFACTORY OEM SERVICE PROCEDURE
Engine Compression
Run engine until it reaches normal operating temperature. Remove all spark plugs and coil high tension wire. Hold throttle valve wide open and operate engine at cranking speed, when checking compression.
COMPRESSION SPECIFICATIONS
| Normal Compression Pressure | ||
| Celica, Corona & Pickup | 171 psi (12.0 kg/cm2 ) | |
| Corolla | 163 psi (11.5 kg/cm2 ) | |
| Starlet | 156 psi (11.0 kg/cm2 ) | |
| Tercel | 177 psi (12.5 kg/cm2 ) | |
| Min. Compression Pressure | 128 psi (9.0 kg/cm2 ) | |
| Max. Variation | 14 psi (1.0 kg/cm2 ) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.