1981 Toyota Pickup BaseFACTORY OEM SERVICE PROCEDURE

Deceleration Fuel Cut System: Operation

On all models except Tercel, the slow speed circuit in the carburetor operates except during prolonged periods of deceleration at high engine speeds. Under these conditions, the computer turns off the fuel cut solenoid valve and the mixture is leaned out. This prevents overheating and afterburning in the catalytic converter.

The Calif. Tercel secondary system and Federal Tercel system are operated only by a vacuum switch. There is no speed sensor or computer, and VCV (Federal models only) is used only for hose connection, not for vacuum control. The Calif. primary system is the same as those on all other models.

Deceleration Fuel Cut Operation

Application Above Engine RPM Above Vacuum In. (mm) Hg
Celica, Corona, Pickup 2590 16.75 (425)
Corolla 2390 16.75 (425)
Land Cruiser 1800 14.00 (355)
Tercel
Β  Calif. 2290(1) 16.75 (425)
Β  Federal Β  8.85 (225)
(1) Primary system only.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.