Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Tesla Model 3 BaseFACTORY OEM SERVICE PROCEDURE
OBD Connector - Retrofit: Notes
Last Modified: 14/08/2024 00:03:56
NOTE:
See PERSONAL PROTECTION
to make sure wearing proper PPE when performing the below procedure.
Tools Required:
- 1115191-00-A - Pick Miniature Soft Grip 90 degree tip 6in
- 1706381-00-A - Cordless Heat Gun
- 1061177-00-C - KIT, WIRE HARNESS REPAIR
- 1944989-00-A - Depinning Tool 45 degrees
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.