2023 Tesla Model S BaseFACTORY OEM SERVICE PROCEDURE

Module - Restraint Control - Remove And Replace: Remove

  1. Move the LH front seat backward.
    G15099579Courtesy of TESLA, INC.
  2. Disconnect LV power. See LV Power (Disconnect and Connect) .
  3. Remove the LH toeboard bracket. See Bracket - Toeboard - LH (Remove and Replace) .
  4. Disconnect the electrical harnesses (x2) from the RCM.
    NOTE: Swing open the locking arm to release the connector. Remove the RH connector first.
    G15099580Courtesy of TESLA, INC.
    G15099581Courtesy of TESLA, INC.
    G15099582Courtesy of TESLA, INC.
  5. Remove and discard the nuts (x3) that attach the RCM to the vehicle, and then remove the RCM from the vehicle.
    NOTE: 10 mm, 10 N.m
    G15099583Courtesy of TESLA, INC.
    G15099584Courtesy of TESLA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.