2022 Tesla Model X BaseFACTORY OEM SERVICE PROCEDURE

EPAS Alignment Check: Procedure

  1. Open the LH front door and lower the LH front window.
  2. Put the vehicle in Service Mode. See Service Mode (Enable And Disable) .
  3. Disable the "Speed Limit" on the touchscreen: Touch Service > Service Settings > Remove Speed Limit  .
    G00634510Courtesy of TESLA, INC.
    G00634511Courtesy of TESLA, INC.
    G00634512Courtesy of TESLA, INC.
  4. Open the alignment portal: Touch Service > Chassis > Applied Offset  .
    NOTE: Make sure the drive rails are on.
    G00634513Courtesy of TESLA, INC.
    G00634514Courtesy of TESLA, INC.
    G00634515Courtesy of TESLA, INC.
  5. Record the Applied Offset Value.
    G00634516Courtesy of TESLA, INC.
  6. Move the vehicle to a flat area with 500 m of space.
    NOTE: The vehicle will need to exceed 10 mph within 500 m for the test to complete.
    G00634517Courtesy of TESLA, INC.
  7. Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect) .
  8. In Toolbox, click Actions/Autodiag  , and then search for "TEST-SELF_EPAS_X_STEERING-CENTER-OFFSET-SERVICE".
    G00634518Courtesy of TESLA, INC.
  9. Click Steering Angle Offset Detection Test for Service  , then enter the "Applied Offset Value" recorded earlier, and then click Run  .
    NOTE: The vehicle will need to be in position before starting the test.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.