Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Tesla Model X BaseFACTORY OEM SERVICE PROCEDURE
Module - Steering Column Control - Remove And Replace: Notes
Last modified: 30/11/2023 01:37:51
NOTE:
See Personal Protection
to make sure proper PPE is worn when performing the below procedure.
- 2023-11-30: Replaced Toolbox routine "PROC-VCLEFT_X_STEERING-COLUMN-CALIBRATION" with "PROC_STEERING_COLUMN_CALIBRATION".
- 2023-09-28: Updated steps per latest time study. The upper steering column shroud, steering column gap hider, and other IP trims no longer need to be removed.
- 2023-08-28: Added part number for the harness retaining clip.
WARNING:
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to [email protected].
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.