Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Tesla Model X BaseFACTORY OEM SERVICE PROCEDURE
TPMS - Sensor ID Drive Learn: Procedure
- Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect) .
- Click the Actions tab, and then search for "TPMS Erase."
- Click PROC_VCSEC_X_TPMS-ERASE-AND-AUTOLEARN
, and then click Run
. Allow the routine to complete.NOTE: This action erases stored TPMS Sensor IDs.
- Disconnect the laptop with Toolbox 3 from the vehicle. See Toolbox 3 (Connect and Disconnect) .
- Drive the vehicle a short distance to verify all four TPMS sensor values are displaying on the touchscreen.NOTE: The sensors will begin displaying values at approximately 5 mph. When vehicle receives communication from the sensors with known IDs, It will quickly connect to them. If tire pressures do not populate, rescan each sensor and try again.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
