Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Tesla Model X BaseFACTORY OEM SERVICE PROCEDURE
Existing Key Present
- Open the LH front door.
- Lower the LH front window.
- Remove the battery insulating tab from the new key fob.NOTE: Tear the short end of the tab at the perforation. Pull the remaining battery insulating tab out of the key fob assembly. Ensure entire tab is removed by confirming both perforated edges are present. If not, remove the battery cover and battery to retrieve the remaining insulating tab.
- Access the Controls
menu.NOTE: Tap the vehicle icon at the lower left of touchscreen.
- Touch Locks from the left pane.
- Touch the + symbol located on the touchscreen.
- Scan your new key fob on the left side of the phone dock.NOTE: Slide the key fob at a slow to moderate speed along the center divider of the wireless charger with the Tesla logo pointing to the left. The scanning request menu will disappear when the new key fob is recognized. Remove the key fob from the wireless charger once recognized.
- Tap existing paired key card on the left side of the phone dock to approve the new key being programmed.
- Verify new key is now active in Keys menu
- Check the function of the newly programmed key fob.NOTE: Use the buttons to lock/unlock the doors, open the hood, open the LH/RH rear doors, and open the liftgate.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
