Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Tesla Model X 100DFACTORY OEM SERVICE PROCEDURE
Enable Service Mode Via Toolbox 3
- Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect And Disconnect) .
- Unlock the vehicle gateway. See Gateway Unlock .
- In Toolbox 3, click the Actions tab, type "Service" into the search field, click PROC_ICE_X_ENTER-SERVICE-MODE , click Run , and then allow the routine to complete.
- Return to the procedure that required Service Mode to be enabled.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.