Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Tesla Model S 100DFACTORY OEM SERVICE PROCEDURE
Module - Sunroof Controller (RHD) - Remove And Replace: Installation
Installation procedure is the reverse of removal, except for the following:
- Reinstall the latest vehicle firmware, or update the firmware if not the latest. See Firmware Reinstall - Touchscreen or Firmware Update .
- For vehicles with a Panoramic Sunroof: Use Toolbox 2 to run the Panoramic Sunroof Calibration, and then run the Panoramic Sunroof Cycle Test.CAUTION: The sunroof opens and closes during Calibration and Cycle Test. Make sure that the glass is clear of obstructions prior to running the Calibration and Cycle Test.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.