Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTESLA2018MODEL 3 BASEREPAIR AND DIAGNOSISGENERAL INFORMATIONHOIST/JACKBODY -- MODEL 3PAINTPAINT DEFECT RECTIFICATIONREMOVE DIRT INCLUSION
2018 Tesla Model 3 Base
Remove Dirt Inclusion
2018 Tesla Model 3 BaseSECTION Remove Dirt Inclusion
- Apply isopropyl alcohol to the general area of the defect, and then wipe the area with a clean microfiber towel.
- While wearing a nitrile glove, run hand over the area around the dirt inclusion and check for fine bumps in the paint.
- If bumps are detected, perform clay treatment on the area before proceeding to the next step.
- If no bumps are detected, proceed to the next step.
- Apply detail spray to the affected area, and clean the affected area with a decontamination mitt using light and straight passes. Continue to the next step when the mitt no longer drags on the paint.
- Install a new sanding disc on the sander.
- Spray the sanding disc with water.
- Set the sander speed according to region, and while the sander is off, place the disc on top of the dirt inclusion.
- NA: lowest speed
- APAC: TBD
- EMEA: TBD
- Keeping the disc stationary and flush with the body panel, activate the sander for 3 seconds, and then turn off the sander.CAUTION: Do not run the sander for more than 3 seconds.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.