2017 Tesla Model X 100DFACTORY OEM SERVICE PROCEDURE

Module - Front Body Controller - BCM - Remove And Replace: Remove

  1. Remove the ECU box from the vehicle ECU BOX (REMOVE AND INSTALL)Β .
  2. Release the screws that secure the bracket inside the ECU box (torque 2.5 N.m).
    G15202871Courtesy of TESLA, INC.
  3. Remove the front body controller.
    G15202872Courtesy of TESLA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.