Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Tesla Model X 100DFACTORY OEM SERVICE PROCEDURE
High Voltage System -- Model X
- High Voltage Testing
- Charge System Inlet
- Onboard Charger
- DCDC Converter
- Rapid Mate And Rapid Splitter
- HV Harnesses
- HV Harness - (Charger To Charge Port) - Remove And Replace
- HV Harness - (Charger To Charge Port (China)) - Remove And Replace
- HV Harness - (Charger To Rear PTC Heater) - Remove And Replace
- HV Harness - (FJB To Front Drive Unit) - 1st Generation - Remove And Replace
- HV Harness - (FJB To Front Drive Unit) - 2nd Generation - Remove And Replace
- HV Harness - (Rapid Splitter To FJB - Small Drive Unit) - Remove And Replace
- HV Harness - (Rapid Splitter To FJB - Large Drive Unit) - Remove And Replace
- HV Harness - (Rapid Splitter To Rear Drive Unit) - Remove And Replace
- HV Harness - (Rapid Splitter To Charger) - Remove And Replace
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
