Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Tesla Model 3 BaseFACTORY OEM SERVICE PROCEDURE
Front Drive Unit -- Model 3
- Front Drive Unit Assembly
- Front Drive Inverter
- Front Gearbox and Halfshafts
- Breather - Front Drive Unit - Remove and Replace
- Filter - Oil - Front Drive Unit - Remove and Replace
- Gearbox Fluid - Front Drive Unit - Check and Fill
- Gearbox Fluid - Front Drive Unit - Drain and Refill
- Halfshaft - Front Drive Unit - LH - Lubricate at Hub
- Halfshaft - Front Drive Unit - LH - Remove and Replace
- Heat Exchanger - Front Drive Unit - Remove and Replace
- Oil Pump - Front Drive Unit - Remove and Replace
- Seal - Axle - Front Drive Unit - LH - Remove and Replace
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.