2017 Tesla Model 3 BaseFACTORY OEM SERVICE PROCEDURE

Determine Defect Risk Level

  1. Inspect the defect(s) and determine whether they are low or high risk.
    • If the defect(s) are low risk, continue to the next step.
    • If the defect(s) are high risk, escalate the repair to a body shop.
    • Low Risk Defect Characteristics 
      • Less than 1.5 mm diameter on flat or near-flat body panels
      • Less than 1.0 mm diameter on or near character lines
      • High or low spots
      • Basic surface paint inclusions
      • Holograms
      • Swirls
      • Solvent pop
      • Overspray
      • Light to medium depth scratches
    NOTE:

    Low Risk Basic Surface Paint Inclusions (1 Of 2)

    G14739374Courtesy of TESLA, INC.
    NOTE:

    Low Risk Basic Surface Paint Inclusions (2 Of 2)

    G14739375Courtesy of TESLA, INC.
    • High Risk Defect Characteristics 
      • Larger than 2.0 mm diameter on flat or near-flat body panels
      • Larger than 1.0 mm diameter on or near character lines
      • Off color inclusions
      • High or low spots larger than 2.0 mm
    NOTE:

    High Risk Off Color Paint Inclusion

    G14739376Courtesy of TESLA, INC.
    NOTE:

    High Risk Defect On Character Line

    G14739377Courtesy of TESLA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.