Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Tesla Model X 90DFACTORY OEM SERVICE PROCEDURE
Module - Intrusion Sensor - Remove And Replace: Removal
- Remove the headliner Headliner (Remove And Replace)
- Place the headliner on a clean work surface with the upholstered side facing down.
- Disconnect the headliner electrical harness from the intrusion sensor module connector.
- Disconnect the intrusion sensor electrical harness connectors (x2) from the intrusion sensor module.
- Release the clips (x2) that attach the intrusion sensor module to the headliner, and then remove the module from the headliner.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.