Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Tesla Model SFACTORY OEM SERVICE PROCEDURE
Module - Sunroof Controller (RHD) - Remove And Replace: Removal
- Move the LH seat to its rearmost position.
- Remove the LH footwell cover Assembly - Cover - Footwell - Driver's (Remove And Replace) .
- Carefully peel back the front LH carpet for access.CAUTION: Take care not to damage component(s).
- Remove the bolts (x3) that secure the LH footwell harness cover (torque 4 N.m).
- Disconnect 12V power. See DISCONNECT 12V POWER .
- Remove the bolts (x3) that attach the controller to the bulkhead (torque 4 N.m).
- Disconnect the sunroof controller harness connectors (x2).
- Remove the controller from the vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.