Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Tesla Model SFACTORY OEM SERVICE PROCEDURE
Car Computer - Remove And Install: Remove
WARNING: This page is about a different car, the 2024 Tesla Model Y, 2023 Tesla Model Y, 2022 Tesla Model Y, 2021 Tesla Model Y, and 2020 Tesla Model Y. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect 12V power. See 12V/LV Power (Disconnect and Connect) .
- Depending on vehicle configuration, remove the fresh intake duct or the HEPA duct.
- Place absorbent material below the car computer coolant hose connections to collect any spilled coolant.
- Release the clips on the coolant hoses connected to the car computer, and then disconnect the coolant hoses from the car computer.
- Plug the female fittings of the coolant hoses.
- Install the car computer fluid port plug over the car computer coolant fittings.
- Remove and discard the nuts that attach the car computer to the body.
- Remove the passenger footwell cover. See Cover - Footwell - Passenger (LHD) (Remove and Replace)
- Remove the front floor mat.
- Remove the RH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace) .
- Remove the RH center console side panel carpet. See Side Panel - Center Console - LH (Remove and Replace) .
- Remove the clip that attaches the front RH carpet to the body, and then fold the front RH carpet rearwards.
- If equipped, remove the knee airbag. See Airbag - Knee - Front Passenger (Remove and Replace) .
- Place absorbent material beneath the car computer to catch any spilled coolant.
- Move the car computer inwards to allow better access to the clips and electrical connectors of the car computer.
- Release the bolt and nut (torque 3.5 N.m) that attach the ground strap to the car computer.NOTE: Discard the nut after removal.
- Release the clips that attach the electrical harness to the car computer.
- Disconnect the electrical harness connectors from the car computer, and then remove the computer from the vehicle.CAUTION: Avoid spilling coolant on the electrical connectors.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
