Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Tesla Model SFACTORY OEM SERVICE PROCEDURE
Section 33 (Instrument Panel -- Model Y)
WARNING: This page is about a different car, the 2024 Tesla Model Y, 2023 Tesla Model Y, 2022 Tesla Model Y, 2021 Tesla Model Y, and 2020 Tesla Model Y. However, it is still accessible from the selected car via links, so may be relevant.
- Instrument Panel
- Beam - Cross Car - Remove And Replace
- Cover - Footwell - Driver - Remove And Replace
- Cover - Footwell - Passenger (LHD) - Remove And Replace
- Cover - Footwell - Passenger (RHD) - Remove And Replace
- Decor Trim - Instrument Panel - Main - Remove And Replace
- Decor Trim - Instrument Panel - Main (RHD) - Remove And Replace
- Decor Trim - Instrument Panel - Main - Rework
- Defrost Cover - Instrument Panel - LH - Remove And Replace
- End Cap - Air Wave - LH - Remove And Replace
- End Cap - Instrument Panel - LH - Remove And Replace
- Finisher - Vent - Remove And Replace
- Gap Hider - Steering Column - Lower - Remove And Replace
- Gap Hider - Steering Column - Upper - Remove And Replace
- Glove Box - With Knee Airbags - Remove And Replace
- Glove Box - With Knee Airbags (Heat Pump) - Remove And Replace
- Glove Box - Without Knee Airbags - Remove And Replace
- Grille - Speaker - Instrument Panel - Remove And Replace
- Housing - Center Display - Remove And Replace
- IP Carrier - Remove And Install
- IP Carrier - Remove And Replace
- NVH Pad - Glove Box - Remove And Replace
- NVH Pad - Instrument Panel - Upper - Remove And Replace
- Vent - Front - LH - Remove And Replace
- Vent - Front - RH - Remove And Replace
- Riser - Instrument Panel - Remove And Replace
- Shroud - Upper - Steering Column - Remove and Replace
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
