2012 Tesla Model SFACTORY OEM SERVICE PROCEDURE

Fluids and Capacities: Fluids

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Tesla Model 3, 2022 Tesla Model 3, 2021 Tesla Model 3, 2020 Tesla Model 3, and 2019 Tesla Model 3. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: The fluids provided in the table below represent the fluids used and approved for use. Using alternative fluids that are not approved by Tesla is done at the risk of the individual repairer and any damage that occurs as a result is not covered under the New Vehicle Limited Warranty or Used Vehicle Limited Warranty.
Component/System Description
Air Conditioning Depending on its intended sales region, the air conditioning system is filled with R134a or R1234yf refrigerant.
  • 1012403-00-B, REFRIGERANT, R134a
  • 2006643-00-A, REFRIGERANT, R1234yf

Β 
For China only, please use the following refrigerant:
  • 1065472-10-A, REFRIGERANT, R134A 13.5KG CYLINDER

If oil needs to be added to the air conditioning system, use the appropiate oil as specified below.

CAUTION: Select the corresponding refrigerant oil type according to different types of compressors. Do not mix different types of A/C system oil.
  • Hanon or Sanden compressor type: use RB100EV A/C oil (part number 1031093-01-A)
  • Denso compressor type: use ND-11 A/C oil (part number 1023305-00-A)
Brake Fluid DOT 4 BASF Hydraulan 404 (part number 1012041-10-C) is the recommended brake fluid. If DOT 4 BASF Hydraulan 404 is not available, DOT 3 Dow 372LB (part number 1060099-00-A) can be used alternatively.
NOTE: The brake fluid filler cap is marked 'DOT 3'. This is the minimum requirement and does not state to only use DOT 3 brake fluid.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.