Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Tesla Model SFACTORY OEM SERVICE PROCEDURE
Navigation Micro SD Card - Media Control Unit - Remove And Replace: Notes
Last modified: 12/05/2023 09:26:17
Revision History:
- 2023-5-23: Updated removal step 4 to state "destroy and discard the Micro SD card after removal".
NOTE:
This procedure replaces the Micro SD card that stores navigation information for Tegra based MCUs. To replace the SD card that has the gateway configuration and information, refer to GATEWAY SD CARD - MEDIA CONTROL UNIT (REMOVE AND REPLACE)Β .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
